Bacharach RDM800 Instalační příručka stáhnout pdf (Strana 2)

The adapter board mounts on the rear of the HGM300 door. Position the adapter board

so as not to interfere with the HGM internal components when the door is shut. Mark

(Figure 1) and drill the board’s four corner holes and center hole in the door. Install the

five standoffs on the rear side of the door using the five black decorative screws on the

front side of the door. Position the adapter board over the standoffs mounted on the

HGM door. Install the five remaining 6-32 screws through the board and into the

standoffs and tighten.

Connect power wiring from the HGM300’s 120V Auxiliary Power terminal block to the

adapter board’s POWER terminal block. Use UL approved wire. Wire polarity does not

matter.

2 of 10

1 2 3 4 5 6 7 8 9 10

Žádné komentáře

Bacharach RDM800 Instalační příručka Strana 2